Polycarbonate plastic vacuum desiccator Laboratory vacuum dryer

Features

1. The shell is made of high-quality polycarbonate injection molding

2. Long period vacuum maintenance: 30 days after vacuuming, the change of vacuum degree is less than 6%

3.Vacuum indicator

4. Leak-proof valve with lock

5. silicon-rubber sealing ring

6. Strong damage resistance, good transparency and light weight: injection molding with high-quality polycarbonate material imported from Germany.

7. Seal without grease: use high-quality silicone rubber ring to seal

8. Fine-tuning of air intake; the valve is a special precision needle valve, which can adjust the air intake in a small amount to avoid

9. Avoid blowing damage to stored items
10. Quick-change joint to connect the exhaust pipe and the needle valve

11. Applicable working temperature: 0ºC-80ºC

12. Dual valve, which allows suction and filling of protective gas (inert gas) at the same time. If not inflated, unused valves can be used as backup valves.

Noted: It can be produced according to the special requirements of customers (such as: changing

material, low temperature application, etc.)

Specifications