Suitable for high adhesive water, acid, alkaline product.

This preparation set can accurately coat film, it’s suitable to co-work with the linear dry time recorder, each film applicator can apply two thickness.

This tester is used to test the minimum film formation temperature of the resin glue emulsion, it means format uniform crack-free film under gradient heat drying condition. The main structure is a metal gradient board, there is cooling and heating source at the ends of board, thus will generate a temperature gradient on the metal board, coat a continuous wet film with uniform thickness on the gradient board, dry air flow to dry the sample, meanwhile the water in sample will be evaporated thus will form film, as temperature on board is different thus will result in different film formation position, find the junction point of continuous transparent film and white opaque film, the junction point temperature can be obtained on the screen, this is so called the minimum film formation temperature.

Six paddles with hemispherical contacts mounted on a carriage.
The stroke bar is driven by the carriage and comes into contact with the new coating layer. It starts from one end and moves longitudinally on the sample. The moving time can be measured by a scale on the edge of the instrument, corresponding to each drying stage of the observation trajectory. The coating was pre-coated on a glass strip having a width of 23 mm and a length of 340 mm, and was applied using a square preparation device.

The Storemer type viscometer is used to measure the viscosity of coatings and paintings, only need to press the handle can start test, can test KU and g value, can lock the test result; built in overload protection program, automatic stop when over-range, equipped with print interface, can output test data to computer.

It’s used for viscosity measurement of coatings and paints, the paddles are driven by the loads.

The Ford cups are made in accordance with ASTM D1200, D333, D365 standards, it’s used to measure the viscosity of inks, coatings and paints. It is made of high-quality aluminum cup with a small hole at the bottom and a capacity of about 100ml. The Ford cup evaluates the viscosity of the material by measuring the time required for a certain volume of sample in the aluminum cup to flow out of the small hole at the bottom, and is widely used in the Americas and European countries.

The Zanh cup can be used for quick viscosity determination at site, each cup with a 30cm length ring handle, a ring at the center of handle can keep the the cup always in vertical when testing. Cup body made of SUS material, cup volume 43ml-49ml.